Toilet

Whether you own a modern one-piece toilet or a classic two-piece design, toilet issues can happen when you least expect them. In this guide, we’ll walk you through the most common toilet problems and simple DIY solutions to keep your bathroom running smoothly.

1. The Toilet Keeps Running

A running toilet is not just annoying — it wastes water and increases your utility bill. The usual culprits are:

• A worn-out flapper valve.
• Improperly adjusted float.
• Faulty fill valve.

How to Fix It:

• Remove the tank lid and inspect the flapper.
• If it’s cracked or warped, replace it — they’re inexpensive and easy to install.
• Adjust the float so the water level sits about an inch below the overflow tube.
• Flush to test and confirm the water stops after filling.

2. Clogged Toilet

A clogged toilet is the most common household plumbing issue. It can be caused by too much toilet paper, non-flushable items, or low water pressure.

How to Fix It:

• Use a flange plunger for a better seal.
• If plunging doesn’t work, try a toilet auger to dislodge deeper blockages.
• Avoid using harsh chemical drain cleaners — they can damage porcelain and pipes.

3. Leaking Toilet at the Base

If you notice water pooling around the base of your toilet, the wax ring seal might be broken.

How to Fix It:

• Turn off the water supply and drain the toilet completely.
• Disconnect the bolts and carefully lift the toilet from the floor.
• Replace the wax ring with a new one, ensuring a snug fit before reseating the toilet.

4. Weak Flush or Slow Draining Toilet

A weak flush often points to a clog in the rim holes or siphon jet. Mineral buildup can reduce water flow.

How to Fix It:

• Pour white vinegar into the overflow tube and let it sit for a few hours.
• Scrub the rim holes gently with a small brush or wire.
• Flush to test water pressure.
  

If the issue persists, consider replacing the flushing mechanism or upgrading to a modern high-power flushing toilet designed for efficiency and power.

5. Toilet Tank Not Filling Properly

When the toilet tank won’t fill, it’s usually because of:

• A malfunctioning fill valve.
• Low water pressure.
• A blocked supply line.

How to Fix It:

• Check that the shut-off valve is fully open.
• Clean or replace the fill valve if debris is blocking water flow.
• Flush the supply line to remove buildup.

If your toilet is old, replacing the toilet fill valve can improve performance instantly.

6. Upgrade Instead of Repairing

If your toilet constantly leaks, clogs, or runs, it may be time for an upgrade. Modern toilets like the Lordear One-Piece Dual Flush Toilet offer:

• Powerful flush with low water usage.
• Sleek, easy-to-clean design.
• Quiet operation.
• Long-lasting ceramic glaze finish.

Explore the Lordear Toilet Collection for durable, water-saving, and stylish bathroom solutions — all with free U.S. shipping.