Kitchen Sinks Lordear

How to Hang a New Drop In Kitchen Sink

Installing a new sink in your kitchen can be a rewarding and relatively easy task, as long as you go in with the right tools and know-how. Here, we’re going to discuss how to properly hang a drop-in kitchen sink.

Tools you’ll need

    • Drill and drill bits
    • Pliers and screwdriver
    • Tape measure
    • Putty knife
    • Caulk gun and caulk

Instructions

    • Start by preparing the sink for installation. Make sure the sink is free of any debris or dirt and then measure it to find the right fit. You want to measure the opening in your countertop and make sure that your new sink will fit into it.
    • Next, you’ll want to prepare the sink opening area. To do this, use a putty knife to remove any old caulking around the sink. Then wipe down the area with a wet cloth to remove any residual dust or debris.
    • Once the sink area is prepped, you can begin to install the sink. Place the sink in the opening and make sure that it’s level and secure. Make sure to press the sink firmly so that any excess caulk is squeezed out. Now use the drill bits to make holes for the faucet and other drains.
    • Now you can secure the sink with screws. Insert the screws into the holes you’ve drilled and tighten them with a screwdriver or pliers. Make sure they are secure and the sink is properly secured to the countertop.
    • The last step is to apply caulk along the top of the sink and countertop. This will not only help create a waterproof seal, but it will also help to keep it looking neat and clean. Make sure to smooth out the caulk with a wet finger to ensure that there are no air bubbles.

Conclusion

Installing a new drop-in kitchen sink can be a rewarding and relatively easy task provided you are prepared and have the right tools and knowledge. Follow the steps above and you can have your sink installed in no time. Hanging a new drop-in kitchen sink is a relatively straightforward process and a great way to update the look of your kitchen. With the right tools and preparation, you can have your new sink installed in no time.

First, gather all the materials and tools you’ll need. You’ll need your new sink, putty knife, screwdriver, adjustable wrench, caulk, mounting clips, and silicones based sealant.

Next, locate the sink’s drainage hole and connect the tailpiece pipe and trap using Teflon tape. Make sure all the connections are secured and watertight before moving onto the next step.

Now measure and mark the sink’s mounting holes, then cut the opening in the countertop with a circular saw. Make sure the opening is large enough to accommodate the sink’s dimensions.

Place the sink upside-down on the countertop and secure it with the mounting clips included with the sink. Place the clips around the sink’s rim and use a screwdriver to tighten them securely.

Time to seal the sink to the countertop. Spread a 1/4” bead of caulk around the sink’s rim and use a putty knife to smooth and seal it. Next, apply a silicone-based sealant around the perimeter of the sink’s rim.

Finally, turn on the water to check for any leaks. If there isn’t any, you’re done and your new kitchen sink is now ready for use.

Hanging a new drop-in kitchen sink is an easy DIY project that can significantly update the look of your kitchen. With the right materials and preparation, it’s a job you can do yourself.

Back to blog

Leave a comment

Please note, comments need to be approved before they are published.